Tach Relocation Bracket Kit

• 1 Fluidamper
• 2 Spacers
• 2 Short Studs
• 1 Long Stud (the other long stud will come from the OE bracket)
• 2 Nuts (2 nuts will be reused from the OE bracket)
• 1 Bracket
• 1 Short Bolt

OE Setup:

             
Page 1 of 5

Relocation Position:

Remove front cover/housing bolts, install long stud that was removed from original bracket and long stud supplied with kit.

Install long studs where front cover/housing bolts were removed.

Page 2 of 5

Install Spacers on long studs.

Studs installed in bracket:

Page 3 of 5

Install bracket with preinstalled studs.

Install Tach Sensor.

Page 4 of 5

Relocated Crank Sensor with wiring attached to front cover bolts.

These bolts were installed where the original sensor studs were removed. Use the short bolt supplied with kit and 1 long bolt that was removed from the new sensor relocation.

Page 5 of 5